|
I. After use, open the water reservoir lid and drain any excess water. Then, with the external use sprayer facing downward, press the button and run the motor to drain any excess water from the sprayer. II. Extend the sprayer from case, wash it in fresh water. Wipe up the moisture, then return the external-use sprayer to the side of the case.
III. Open the water-in lid, press the case and water reservoir at the same time, until case comes into the water reservoir fully. Faster the water-in lid. IV. Put the cleanser, internal-use sprayer and nursing sprayer into plastic bag, then in handbag.
HOW TO USE THE NURSING SPRAYER
I. Install the nursing sprayer. II. Open water-in lid and add cleansing liquid. Turn the top of the sprayer to select different spraying mode. III. Put the loop handle around wrist while holding the appliance, point where you wash and press the button. "rotate nozzle to change pattern of spray"
INSTALLATION OF BATTERY
Remove the battery lid with the supplied batter lid opener attached the chord on the handbag. Put in the battery in the right direction according to the given symbols of mode and cathode. Fasten the battery lid when replacing the battery, ensure the surface of the battery case is dry.
FILLING WITH WATER
I. Open the water-in lid at the bottom stretch out the case until the bottom comes out fully. II. After filing fasten the lid. |