1. Remove the existing toilet seat. To access screw, push lid upward located all the way at the end of seat with sharp object. Take out seat by loosening screw and holding bolt from bottom.

2. Turn off the main water valve.

3. Take out exiting water pipe. Loosen fill valve just below the water tank and compression nut from control valve. Then take out water pipe by tapping fill valve.

4. Flush down all the remaining water in water tank.

1. Be sure to shut off main valve.

2. Use the supplied hose to connect the body joint of the main unit to the
branching valve. tighten the coupling nuts at the body joint and the
branch outlet.

3. Be sure not to over tighten flexible hose at flush tank end.
Use only hand pressure.

4. Using Teflon tape is recommended.

5. Shield the nozzle with your hand to protect the water from spraying too 
far during the trial operation.

6. Press the CLEANSING button to test the water stream.

The unit will not operate properly if the strainer is clogged.
Be sure to clean the strainer.

1. Close the shutoff valve.

2. Flush the toilet to empty the flush tank.

3. Unscrew the nut.

4. Clean the strainer using a small brush.

5. Re-screw the nut.

6. Open the shutoff valve. 

CLEANSING
Warm water cleanses the rear area thoroughly and refreshingly.
60 SECOND AUTOMATIC SHUT-OFF!

WATER PRESSURE ADJUSTMENT
Water pressure is adjustable to 4 levels,
as desired.

TEMPERATURE ADJUSTMENT
Water temperature is adjustable to 4 levels.
This model has an electric built-in water heater.

BUILT-IN WATER PUMP
A built-in water pump maintains an even water pressure regardless of source water pressure.

SPACE CONSERVING
Its compact and simple design conserves space.
IT MAY BE INSTALLED ON EITHER SIDE, BASED ON AVAILABLE SPACE OR USER PREFERENCE.

Quality approved by UL
SB-100, Our European model obtained GS Mark.
It is Practical, Convenient, and Clean!